MOTOR INSTALLATION WITH USALS PDF

Motor is not moving at all. Coax is not connected correctly to motor or receiver Cable is too long over 75ft There is a bad connector or short in connector Motor needs to be reset to the Zero position. Use solid copper core RG6 coaxial cable. In some cases, it is best to use RG11 coaxial cable for longer runs. Inspect all connectors for any wires touching the center core causing a short. Also, bad quality connectors may rust or cause moisture to get in.

Author:Zulkikasa Doulrajas
Country:Comoros
Language:English (Spanish)
Genre:Personal Growth
Published (Last):18 December 2013
Pages:143
PDF File Size:18.70 Mb
ePub File Size:17.66 Mb
ISBN:975-7-40340-246-9
Downloads:24875
Price:Free* [*Free Regsitration Required]
Uploader:Taurisar



Motor is not moving at all. Coax is not connected correctly to motor or receiver Cable is too long over 75ft There is a bad connector or short in connector Motor needs to be reset to the Zero position. Use solid copper core RG6 coaxial cable.

In some cases, it is best to use RG11 coaxial cable for longer runs. Inspect all connectors for any wires touching the center core causing a short. Also, bad quality connectors may rust or cause moisture to get in. The motor will move to 0-position and reset. In the case of Satcontrol motor, it will move all the way to East then move to 0-position. Any leaning of the mast one direction or another will cause the motor not to track the ARC correctly.

Find your correct Latitude value for your zip code here , then adjust the motor elevation accordingly. True South for Chicago is , for San Francisco is Make every effort to align dish, lnbf arm, and motor on the same straight line.

Start by setting dish elevation to calculated value. Adjust dish elevation Up or Down from calculated value no more than one degree at a time. Motor is not able to move back from farthest East or West towards the center. Dish might be too heavy for the motor to handle. Make sure you use proper size dish with your motor. Heavier dishes will cause much strain on the motor and eventually it may damage the internal gears of the motor or burn the motor.

Such damage is not covered by any warranty. Other problem not listed here. Well, by adding a motor to your system you will be able to receive satellite channels from several satellites instead from one only. That way you will gain many more channels economically without investing in many dishes and switches. Fc90u sample.

2008 ACURA TL OWNERS MANUAL PDF

Installing a Motorized Satellite System with an HH-Mount Motor, DiSEqC & USALS Compatible Motors

The angle can be set according to the markings on the side of the motor. Some motors even include the latitude markings as an additional aid. Setting the elevation angle 4. Attach the dish to the motor shaft - make sure the dish is at right angles to the motor and pole. Set the adjusted declination angle on the dish - your latitude will also determine the declination angle - see above.

D&D 3.5 CITY OF SPLENDORS WATERDEEP PDF

STAB HH90 DiSEqC Horizon To Horizon HH USALS Motor

Mizahn It motor installation with usals very important to make sure the HH motor is fixed to a perfectly vertical plumb mast Picture 1. Sadoun HH Motor Forums. Slightly loosen the witg fittings — this will enable you to just rotate the mofor about the pole. As a general rule you want to find the closest satellite to your longitude, which will always be the highest satellite in the sky and gives you a better chance of tracking the arc, in my case I chose Thor 1W If you were in Dublin say, you would be better with Atlantic Bird at 5W.

JOHN HOEFLE PDF

HH90 USALS | Satellite Antenna Rotor - Stab

.

CLAN NOVEL BRUJAH PDF

MOTOR INSTALLATION WITH USALS DOWNLOAD

.

Related Articles